Crown Nut problem. Any ideas? Help

GeNX

I tightended my ball joint and tie rod to the specified torque and now my cotter pins are well below the crown.

ps the car was in the air when I torqued them.

Jaker

I've had that happen plenty. The only thing I ever do about it, is try and twist the ends of the cotter pin up into the slots of the nut to try and stop them turning. I've never had one back off on me.

949

you could put in a thick washer.

superhatch

If you feel like redoing it some blue loctite would probably give you an added level of security.

GeNX

Thanks I feel a little better now. I might try two bolts where I can and locktight/washer where I can't. I heard this is a common problem with aftermarket parts. At first I thought maybe they forgot to grease in the boot.